Roland KR-17 Electronic Keyboard User Manual


 
8
IMPORTANT NOTES
652
Floppy disks have a “write protect” tab which can protect
the disk from accidental erasure. It is recommended that
the tab be kept in the PROTECT position, and moved to
the WRITE position only when you wish to write new
data onto the disk.
653
The identification label should be firmly affixed to the
disk. Should the label come loose while the disk is in the
drive, it may be difficult to remove the disk.
654
Store all disks in a safe place to avoid damaging them, and
to protect them from dust, dirt, and other hazards. By
using a dirty or dust-ridden disk, you risk damaging the
disk, as well as causing the disk drive to malfunction.
655
Disks containing performance data for this unit should
always be locked (have their write protect tab slid to the
“Protect” position) before you insert them into the drive
on some other unit (except the PR-300, or a product in the
HP-G, MT, KR, or Atelier families), or into a computer’s
drive. Otherwise (if the write protect tab remains in the
“Write” position), when you perform any disk operations
using the other device’s disk drive (such as checking the
contents of the disk, or loading data), you risk rendering
the disk unreadable by this unit’s disk drive.
Before Using CDs
Handling the CD Drive
Add
Avoid using the unit immediately after it has been moved
to a location with a level of humidity that is greatly
different than its former location. Rapid changes in the
environment can cause condensation to form inside the
drive, which will adversely affect the operation of the
drive and/or damage discs. When the unit has been
moved, allow it to become accustomed to the new
environment (allow a few hours) before operating it.
Add
Remove any disc from the drive before powering up or
down.
Add
To avoid the risk of malfunction and/or damage, insert
only discs with into the CD drive. Never insert any other
type of disc. Avoid getting paper clips, coins, or any other
foreign objects inside the drive.
Add
Do not subject to vibrations or physical shock during use,
and do not move the unit while the power is turned on.
Add
The pickup is of dust-resistant construction. Do not use
pickup cleaners or other such materials, as they may
damage the pickup.
Handling the CDs
Add
When handling the discs, please observe the following.
Do not touch the recorded surface of the disc.
Do not use in dusty areas.
Do not leave the disc in direct sunlight or an enclosed
vehicle.
801
Avoid touching or scratching the shiny underside
(encoded surface) of the disc. Damaged or dirty CD-ROM
discs may not be read properly. Keep your discs clean
using a commercially available CD cleaner.
Add
Keep the disc in the case.
Add
Do not keep the disc in the CD drive for a long time.
Add
Do not put a sticker on the label of the disc.
Add
Wipe the disc with a soft and dry cloth radially from
inside to outside. Do not wipe along circumference.
Add
Do not use benzine, record cleaner spray or solvents of
any kind.
Add
Do not bend the disc. Bending discs may prevent proper
reading and writing of data, and may further result in
malfunction.
203
* GS ( ) is a registered trademark of Roland Corpo-
ration.
* XG lite ( ) is a registered trademark of Yamaha Corpo-
ration.
207
* Apple and Macintosh are registered trademark of Apple
Computer, Inc.
210
* IBM and IBM PC are registered trademark of International
Business Machines Corporation.
220
* All product names mentioned in this document are trade-
marks or registered trademarks of their respective owners.
Rear side of the disk
Write
(can write new data onto disk)
Protect
(prevents writing to disk)
Write Protect Tab
KR-17_15_e.book 8 ページ 2004年12月6日 月曜日 午後1時54分