Filter
Top Products
14
CY-15R/CY-14C (V-Cymbal Ride/Crash)
1.
Use the included tuning key to tighten the stopper bolt.
The stopper keeps the V-Cymbal from turning, and prevents the cables from catching or getting tangled on the stand.
fig.21.e
2.
Position the Roland logo on the farther side, as viewed from the performer.
3.
Tighten the felt washer and the wing nut to obtain the desired movement.
fig.22.e
4.
Secure the cables in place with the cable tie, while leaving some slack in the cables to ensure that they
are not pulled by the movement of the cymbal units when struck.
fig.23.e
* Take care to ensure that the cables do not touch the cymbal units and/or the stand. A cable touching a cymbal unit or a stand may cause
double sounding or other incorrect operation.
* Double sounding may occur if the wing nut is loose.
* Do NOT
use the washer or felt included with the cymbal mount.
Mounting on the Stand
Stopper
(Be sure to orient
it correctly)
Tighten the bolt with a
commercially available
drum key
Position the Roland logo
on the opposite side of
the playing area
Felt Washer
Wing Nut
Tighten it
not to slip
Wind the
cable tie
twice
Leave some
slack in the
cable(s)
Turn back to
fix the cable(s)
TD-20K_e.book 14 ページ ２００６年１２月７日 木曜日 午前９時２４分