Filter
Top Products
7
KD-120 (V-Kick Trigger Pad)
5.
Loosen the T-bolts for the stand and mount the legs on the stand.
Install the legs as shown in the figure so that the ends of the legs protrude by about 2 cm.
fig.11.e
6.
Tighten the T-bolts to secure the legs to the stand.
7.
Lift the KD-120 and place the stand and the four legs upright.
8.
Adjust the angle of the head surface so that it’s at a right angle to the floor.
Use the included tuning key to loosen the bracket bolts you tightened in step 3, and adjust the angle of
the KD-120 pad so that the head surface is at a right angle to the floor.
9.
Attach the included plastic beater on your kick pedal.
10.
Mount the kick pedal on the KD-120.
* Make sure there is about 1 cm of space between the two to keep the kick pedal’s chain (or belt) from touching the hoop of the KD-120 pad
during play. Also, if the kick pedal has no under-plate, then arrange the stand’s plate section at a right angle to the floor.
fig.12.e
11.
Make any fine adjustments necessary and tighten the stand brackets to make sure the KD-120 is secure
on the stand.
Make sure the KD-120’s four legs and heel portion of the kick pedal is securely on the floor by loosening
the stand’s T-bolts and adjusting the length of the legs.
* If the kick pedal has no under-plate, then arrange the stand’s plate section at a right angle to the floor.
12.
Adjust the striking point for the beater.
Normally the beater’s striking point is adjusted to fall at the center of the head.
Adjust the striking point so that it doesn’t extend beyond the cushion on the back of the head. Moving
the striking point closer to the sensor increases the sensitivity, so carry out fine adjustment to suit your
preferences.
Extend the leg by about 2 cm.
Mount the legs on the stand.
T-bolt
If the kick pedal has no under-plate, then arrange
the stand’s plate section at a right angle to the floor.
90˚
Prevent contact
between the
hoop and plate.
Allow sufficient
clearance
here.
TD-20K_e.book 7 ページ ２００６年１２月７日 木曜日 午前９時２４分