Samson XML410 Music Mixer User Manual


 
Owner's Manual
15
XML POWERED MIXERS
Speaker Outputs - XML610 & XML910
The XML610 and XML910 powered mixers contain two mono power ampliers and, depending on the operating mode,
the two ampliers can be used independently for LEFT and RIGHT MAIN outputs or for MONO MAIN + MONITOR outputs.
NOTE: Use the Power Amp MODE switch to select which signal is sent to the speaker output jacks.
The total impedance load for each amplier must not exceed 4 Ohms, therefore, if you want to only connect a single
speaker to each amp output, use a 4–8 Ohm speaker.
You can connect up to four speakers at one time. One speaker with an impedance of 8 Ohms can be connected to each
of the amp’s Speakon and 1/4” jacks. The Speakon and 1/4” jacks are wired in parallel, so the total impedance when two 8
Ohm speakers are connected is 4 Ohms.
42. AMP 1 Speaker Outputs - The AMP 1 output has one Speakon and one 1/4” phone connector wired in parallel. These
powered outputs can be used to connect your left side main PA speaker when using the XML610 or XML910 in MAIN/
MAIN mode. When operating in MAIN/MONITOR mode, the AMP 1 powered output connectors are used to connect
left and right side MAIN PA speakers.
43. AMP 2 Speaker Outputs - The AMP 2 output has one Speakon and one 1/4” phone connector wired in parallel. These
powered outputs can be used to connect your left side main PA speaker when using the XML610 or XML910 in MAIN/
MAIN mode. When operating in MAIN/MONITOR mode, the AMP 2 powered output connectors are used to connect
to oor or side ll monitors facing the performers.
43 42