Filter
Top Products
Owner's Manual
19
XML POWERED MIXERS
Speaker Connection - XML410
The XML410’s power amplier section can be congured to operate several ways, depending on the setting of the power
amp MODE switch located on the front panel. This allows you to choose whether you need MAIN plus MONITOR ampli-
ers to power your speakers, or if you just need more power for the MAIN speakers.
There are three ways in which speakers can be connected to the XML410:
1) A single speaker can be connected to the output jack of AMP 1 and AMP 2,
2) Two speakers can be connected in parallel to the output jacks of AMP1 and AMP 2, or
3) A single speaker can be connected to the BRIDGE jack (bridge connection). For each of these situations, the required
speaker impedance will dier.
Refer to the following diagram, and make sure that the speaker impedance is not less than the specied value.
When connecting one speaker to AMP1
and one speaker to AMP 2, use speakers
with a 4–8 Ohm impedance rating.
When connecting two speakers to AMP 1 and two speaker to
AMP 2, use speakers with an 8–16 Ohm impedance rating.
When the POWER AMPS
are in BRIDGE mode, use a
speaker with an 8–16 Ohm
impedance rating.
Additional, or alternative ampliers can be connected to the MAIN OUT and MONITOR OUT jacks on the front panel.