Filter
Top Products
Cheetah 18 Installation Guide, Rev. A 45
LC drives
LC drives sectionSetting the SCSI ID jumpers
The SCSI ID for ST118202LC drives is normally set over the
SCSI bus by the host system. You can also use the J6 jumper
block to set the SCSI ID (see Figure 16).
Figure 16. Setting the SCSI ID on ST118202LC drives
SCSI ID = 0 (default)
Note:
[1] Do not remove
cover from pins
13 through 20
(darkened area).
Jumper Plug
(enlarged to
show detail)
J6
Drive
Front
Pin 1
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
SCSI ID = 8
SCSI ID = 9
SCSI ID = 10
SCSI ID = 11
SCSI ID = 12
SCSI ID = 13
SCSI ID = 14
SCSI ID = 15