Filter
Top Products
Configuring the receiver
20 |
Tourguide 1039
Changing the receiving frequencies of the channels – “Tune”
Via the “Tune” menu item, you can change the receiving frequency of a channel.
The receiver’s channels have been factory-preset to receiving frequencies that
are intermodulation-free. However, you can change the factory-preset frequencies.
Within one frequency range, up to 32 transmission links can be operated
simultaneously.
To change the receiving frequency of the channel:
Adjusting the visibility of the receiving channel – “Active”
Possible settings: activated and visible “On”, deactivated and hidden “Off”
Via the “Active” menu item, you can show or hide the receiving channel. An acti-
vated channel is visible on the standard display and can be selected. A deactivated
channel is invisible on the standard display and cannot be selected.
It is vital to observe the notes on frequency selection in the chapter
“Matching the transmitter to the receiver” on page 22.
Select the MHz
value and confirm
Select the kHz value;
store the setting
Tune Tune
Call up “Tune”
Setup Ch 2
Tune
“Stored”
863.500 MHz
864.500 MHz
864.300 MHz
SET SET
SET
̈ Press the rocker button to adjust the frequency in MHz steps.
̈ Press the SET button to confirm the MHz setting of the frequency.
The kHz section of the frequency is highlighted.
̈ Press the rocker button to adjust the frequency in 25 kHz steps.
̈ Press the SET button to store the setting.
“Stored” appears on the display panel.
SET
SET
Adjust the visibility
and confirm
Store the setting
Active Active
Call up “Active”
Setup Ch 2
Active
On Off
“Stored”
On
SET SET
SET