Filter
Top Products
24
Adjusting settings via the operating menu
The extended menu “Advanced Menu“
Setting the transmission frequencies and the frequency banks
“U1” to “U6” – “Tune”
Via the “Tune” menu item, you can:
1. set a transmission frequency to be stored in the current channel of the
frequency bank (“U1” to “U6”)
2. or select a frequency bank (“U1” to “U6”) and a channel and assign this
channel a transmission frequency.
Setting a transmission frequency for the current channel
̈ Set the desired frequency.
When you have selected one of the system banks and then select
the “Tune” menu, the radio microphone automatically switches to
channel 1 of the frequency bank “U1”. In this case, “U1.1” briefly
appears on the display panel.
Upon delivery, the channels of the frequency banks “U1” to “U6”
are not assigned a transmission frequency.
When you are in the “Tune” menu item, the RF signal is
deactivated.
It is vital to observe the notes on frequency selection on page 27.
̈ Move the multi-function switch until the “Tune” menu item
appears.
̈ Press the multi-function switch
.
The frequency selection appears.
̈ Press the multi-function switch.
Your settings are stored.
You are back to the operating menu.
Tune
B.Ch: U1. 1
B.Ch: U1. 1
Tune
Advanced
Menu
Tune
“Stored”
543.200 MHz
543.200 MHz 543.200 MHz
Select the frequency
bank and confirm
Select the channel;
store the setting
Call up “Tune”
(special function)