Filter
Top Products
26
Microphone sensitivity of the SKM 5200 and the SKM 5000:
Adjusting the low-cut frequency – LOWCUT
To reduce unwanted low-frequency noise such as engine, wind
and rumble noise, you can activate a low-cut filter. The low-cut
frequency can be set to 190 Hz or 120 Hz.
If you do not want to reduce low-frequency signal portions, select
the setting “FLAT”.
Selecting the standard display – VIEW
Via the “VIEW” menu, you can select one of the following standard
displays:
The selected standard display is shown
y after switch-on,
y after the menu settings have been displayed in display mode.
Loading the factory-preset default settings – RESET
Via the “RESET” menu, you can load the factory-preset default
settings. After the reset, the standard display is shown on the
display panel.
SKM 5200:
Setting in dB
–40 –30 –20 –10 0
SKM 5000:
Switch position
12345
Transmission
frequency “FREQ”
Channel
“CHAN”
Name
“NAME”
Low-cut frequency flat
Microphone sensitivity –20 dB
Name 5200
Standard display frequency
Autolock function deactivated
Channel FIX 01
Frequencies in the channel bank “VAR” are reset
CH
MHz
RF
CH
CH
RF
RF
SKM 5200_512717_0506_Sp6.book Seite 26 Donnerstag, 7. Dezember 2006 3:28 15