Filter
Top Products
LX2 HAND-HELD MICROPHONE TRANSMITTER SETUP
Battery Installation (Figure 11)
1. With the transmitter PWR ON/OFF switch in the OFF position, hold the upper
part of the transmitter and unscrew the battery cover.
LX2 MICROPHONE-TRANSMITTER BATTERY INSTALLATION
FIGURE 11
2. Install a fresh 9V alkaline battery (DURACELL MN1604 recommended).
Make sure the battery terminals match the terminals in the transmitter.
3. Replace the battery cover.
Installing the Anti–Roll Device
The rubber anti-roll device prevents hand-held microphones from rolling off
onto the ground when they are set down on a flat surface, such as a table or
speaker cabinet. The anti-roll device proves an important safeguard in stage si-
tuations where the LX2 may be used by inexperienced microphone handlers.
To install the anti-roll device, simply slip it over the microphone handle and
slide it up so that it is positioned just below the label under the microphone grille,
as shown in Figure 12.
ANTI-ROLL DEVICE INSTALLATION
FIGURE 12
Operating the LX2 Hand-Held Microphone Transmitters (Figure 13)
1. Press the POWER switch on the LX88-II receiver ON.
2. Slide the transmitter POWER ON/OFF switch to the PWR position. Check the bat-
tery level. See
Checking the Transmitter Battery
.
3. Check the RF indicator on the LX88-II receiver to see if the radio signal is
being received.
4. Slide the transmitter ON/MUTE switch to the ON position and begin speaking
or singing.
NOTE: If the red PEAK light on the receiver does not flicker during the loud-
est sounds, the transmitter gain may need to be increased. See the
Trans-
mitter Audio Gain Adjustment
section.
5. During the performance or presentation, slide the ON/MUTE switch to the
MUTE position when the microphone is not being used.
6. When the performance or presentation is over, slide the transmitter POWER
ON/OFF switch to the OFF position to conserve battery power.
LX2 HAND–HELD MICROPHONE SYSTEM OPERATION
FIGURE 13
LX2
TRANSMITTERS
LX88-II
RECEIVER
8
9