Filter
Top Products
BODY-PACK TRANSMITTER SETUP
LX1 Body-Pack Transmitter Battery Installation (Figure 14)
-+
FIGURE 14
LX1 BODY–PACK TRANSMITTER BATTERY INSTALLATION
1. With the transmitter POWER ON/OFF switch in the OFF position, press down
on the OPEN side of the battery compartment cover, slide it back and flip it open.
2. Insert a new 9V alkaline battery in the compartment (DURACELL MN1604
recommended). Observe proper battery polarity (“+/–”).
3. Close Battery compartment cover.
Operating LX1 Body-Pack Transmitters (Figure 15)
LX1 BODY–PACK SYSTEM SETUP AND OPERATION
FIGURE 15
LX88-II
RECEIVER
LAVALIER
MIC
WA302 INSTRUMENT
ADAPTER CABLE
WM98 MIC
& A98KCS
HORN MOUNT
WH10
HEADSET
NOTE: The LX1 body-pack system is designed for use with other equipment
which is not included, such as lavalier microphones, guitars, headset micro-
phones, etc. See your Shure dealer for details on ordering the proper equip-
ment for your needs.
1. Clip the LX1 body pack transmitter to your belt or guitar strap.
2. Connect the lavalier microphone, headset or instrument adapter cable to the
body–pack transmitter (Figure 16).
3. Press the POWER button on the LX88-II receiver ON.
4. Turn the transmitter POWER switch ON.
Check Power/Battery fuel gauge.
5. Check the RF Signal Indicator on the LX88-II receiver to see if the RF
signal is being received.
MICROPHONE CABLE OR
WA302 INSTRUMENT ADAPTER
CABLE
LX1 BODY-PACK TRANSMITTER CABLE CONNECTION
FIGURE 16
6. Slide the transmitter ON/MUTE switch to the ON position and begin speaking
or playing your instrument.
NOTE: If the red PEAK light on the receiver does not flicker during the loud-
est sounds, the transmitter gain may need to be increased. See the
Trans-
mitter Audio Gain Adjustment
section.
7. During the performance or presentation, slide the ON/MUTE switch to the
MUTE position when the system is not being used.
8. When the performance or presentation is over, slide the transmitter POWER
ON/OFF switch to the OFF position to conserve battery power.
10
11