Filter
Top Products
10
Name and function of each part
AUX OUTPUT
MONO INPUT
INSERT
10
LINE
MIC
INSERT
8
LINE
MIC
7
8
R
L(MONO)
4
3
6 58 7
R L
R
L(MONO)
R
L(MONO)
R
L(MONO)
RL
R
L(MONO)
R
L(MONO)
L
R
+48V
R
L
RL
L
R
OUT IN
2TR
MASTER
STEREO INPUT
ST1ST2ST5ST6
ST3ST4ST7ST8
MONITOR
OUT
GRP/
DIRECT
OUT
TAPE
IN
INSERT
OUTPUT
ON
OFF
8
69!¡!™
!£
!º
47
5
0
5 STEREO INPUT connectors
Phone jacks (ST1 – ST4)
(Tip: hot, Ring: cold, Sleeve: ground)
(Balanced, reference level: +4/ –10 dBu)
Phone jacks (ST6, ST8)
(Unbalanced, reference level: –10 dBu)
Phono jacks (ST5, ST7)
(Unbalanced, reference level: –10 dBu)
These are input connectors for the STEREO INPUT
channels. Line level output equipment with a
reference level of between +4 dBu and –10 dBu can be
connected for ST1 - ST4, and line level output
equipment with a reference level of –10 dBu can be
connected for ST5 - ST8 in stereo. Signals are internally
distributed to the R side when only the L (MONO)
connector is connected for ST1 - ST4, ST6 and ST8.
6 2TR IN connectors
Phono jacks (Unbalanced, reference level: –10 dBu)
These are connectors to input signals, such as those
from DAT or MD recorders. The level is controlled by
the 2TR IN level control on the MASTER section.
7 GRP/DIRECT OUT connectors
Phono jacks (Unbalanced, reference level: –10 dBu)
These output each GROUP bus signal. When the
DIRECT button for the MONO INPUT 1 - 8 channels is
turned on, they become direct output connectors that
output post fader signals from each MONO INPUT
channel.
1 MONO INPUT MIC connectors
XLR-3-31 type
(Balanced, reference level: –60 - –10 dBu)
(Pin No.1: ground, No.2: hot, No.3: cold)
These are input connectors for the MONO INPUT
channels. Microphones can be connected.
2 MONO INPUT LINE connectors
Phone jacks
(Balanced, reference level: –40 - +10 dBu)
(Tip: hot, Ring: cold, Sleeve: ground)
These are input connectors for the MONO INPUT
channels. Line level output equipment can be
connected.
3 MONO INPUT INSERT connectors
Phone jacks
(Unbalanced, reference level: –3 dBu)
(Tip: output, Ring: input, Sleeve: ground)
These are INSERT IN/OUT connectors for the MONO
INPUT channels. External equipment can be inserted
before the installed equalizer. Compressors and gates,
etc. are connected.
4 TAPE IN connectors
Phono jacks (Unbalanced, reference level: –10 dBu)
These are TAPE IN connectors for MONO INPUT
channels. They connect the output for each track, such
as from a multi-track recorder, etc., and are used for
monitoring or laying down tracks.
Back panel section