Filter
Top Products
12
System Configuration
System example when operating the SRP-X700P with the default
setting when shipped from the factory
LINE4 INPUT
LINE3 IN
AC IN
+48V
+48V
+48V
+48V
1234
21
3
4
5
6
L
R
FRONT
RS-232C
COMPONENT/RGB
B
7
8
1
2
MIC INPUT
LINE OUTPUT
ACD E F
VIDEO
ANT IN a
ANT IN b OUTPUT
R/R-Y
VIDEO
SPEAKERS
REC OUT
REMOTE
PARALLEL
S VIDEO
S VIDEO
CONTROL S
IN
OUT
PROJECTOR CONTROL
MIC5/LINE1 IN
OUTPUT
IMPEDANCE USE
4-16
70V LINE
G/Y B/B-Y
SYNC/HD
VD
L
R
L
L
R
REAR
CENTER
WOOFER
FRONT
L
R
REAR
CENTER
WOOFER
L
R
ON
OFF ON
OFF ON
OFF ON
OFF
MIC
(+48V)
LINE
MIC
(+48V)
LINE
1
2
3
4
CH-1CH-2
IMPEDANCE USE
4-16
IMPEDANCE USE 32
-10k
DC
9V OUT
35mA MAX
DC
9V OUT
35mA MAX
R
CIRCUIT
BREAKER
PUSH RESET
MIC6/LINE2 IN
CONTROL S
RS-232C
IR
transmitter
MD recorder
Component
5.1 channel surround
VHS VCR
RGB
AUDIO
RGB
AUDIO
PC 1
PC 2
CD player
To power outlet
Center speaker (C) Sub woofer (SW)
Power amplifier
Power amplifier
Power amplifier
Ceiling speaker
Surround speaker (LS) Surround speaker (RS)
USB
USER CONTROL PANEL
To power outlet
LCD data projector
Front speaker (L) Front speaker (R)
R/G/B/HD/VD Y/R-Y/B-Y
VIDEO
S VIDEO
RS-232C
DVD player
• You can realize the above system configuration with the default setting of the SRP-X700P. You can use the system without changing any setups from the supplied software SRP-X700P Manager.
• You can control the VHS, DV and DVD, can select channel of the LINE4 INPUT terminal, and can control the sound volume of microphone and AV equipment from the supplied software User
Control Panel. (CD and MD cannot be controlled.)
• VHS, DV and DVD cannot be controlled from the front panel of the SRP-X700P.
• The system configuration shown above uses the two unit of the UHF synthesizer tuner unit WRU-806B (option).
• If you want to use an electret condenser microphone for MIC3 and MIC4, set the +48 V button of the corresponding channel to ON.
• Connect the VPL-FX51 as a projector through RS-232C.
• Install the IR transmitter VM-50 in the SRP-X700P or in the location inside a rack that allows its receptor block to receive the remote control signal. For the installation of the VM-50, see “How to
Control AV Equipment from the SRP-X700P
”
on page 11.
• If you use VHS and DV that can select their remote control mode, set the remote control mode of VHS to “VTR3” and set the remote control mode of DV to “VTR4”.