Filter
Top Products
Transient Designer
10
The ACTIVE switch operates a hard-bypass relay circuit to switch
the channels in and out of processing and a status LED indicates
that the channel is active.
The unit also switches to relay hard-bypass automatically in the
case of a power failure,either on the primary or secondary side of
the power supply, or when the unit is turned off at the POWER
switch.
If the T
RANSIENT
DESIGNER
is operated in the LINK mode (see 5),
channel one's (or three's) ACTIVE also switches channel two (or
four) in and out. Note that channel two's ACTIVE status-LED will
also follow channel one's ACTIVE status.
The SIGNAL-LED indicates an incoming signal with a level excee-
ding -40dB. In complex studio arrangements the LED indication
helps to check if a signal actually arrives at the T
RANSIENT DESIGNER.
With the ATTACK control, the attack period of a signal can be
emphasised or attenuated by up to 15dB. For detailed informa-
tion about the mode of operation of the ATTACK control please
read the section 'Tech Talk' on pages 7 and 8.
5
3
4
2
1
Control elements
Signal-LED
2
Active
1