Filter
Top Products
D1335603_T770_880_990_MXP_User_Manual
202
Supported DVI cables:
TANDBERG supports DVI-D Single-Link, DVI-A and DVI-I Single-Link format cables.
DVI-D cables transmit digital T.M.D.S. signals, DVI-A cables transmit analog VGA signals and
DVI-I cables can transmit either digital or analog signals.
It is possible to extend existing DVI cables by the use of extension cables. The maximum cable
length however, is 5 meters. Going beyond that may result in quality loss.
DVI-I - Combined Analog and Digital Connector Pin Assignments:
Pin Signal
Assignment
Pin Signal
Assignment
Pin Signal
Assignment
1 T.M.D.S.
Data2-
9 T.M.D.S.
Data1-
17 T.M.D.S. Data0-
2 T.M.D.S.
Data2+
10 T.M.D.S.
Data1+
18 T.M.D.S. Data0+
3 T.M.D.S.
Data2/4 Shield
11 T.M.D.S.
Data1/3 Shield
19 T.M.D.S.
Data0/5 Shield
4 T.M.D.S.
Data4-
12 T.M.D.S.
Data3-
20 T.M.D.S. Data5-
5 T.M.D.S.
Data4+
13 T.M.D.S.
Data3+
21 T.M.D.S. Data5+
6 DDC Clock 14 +5V Power 22 T.M.D.S. Clock
Shield
7 DDC Data 15 Ground (return
for +5V, HSync
and VSync)
23 T.M.D.S. Clock+
8 Analog Vertical
Sync
16 Hot Plug Detect 24 T.M.D.S. Clock-
C1 Analog Red C2 Analog Green C3 Analog Blue
C4 Analog
Horizontal
Sync
C5 Analog Ground
(analog, R, G &
B return)
5.1.2 Audio
4 Audio Inputs
2 microphone inputs (balanced, 24V phantom powered) via XLR connectors.
2 audio inputs (line level) via RCA connectors.
All audio inputs are active by default. For further information, refer to chapter 4.5 Audio.
Audio input connector specification:
Connector label Microphone(s) Audio input(s)
Signal type Balanced Unbalanced
Connector (codec) XLR-F, pin 1-gnd,
pin 2 hot, pin 3-
cold/neutral
Female RCA/phono,
sleeve-ground,
centre-signal