Filter
Top Products
18
TASCAM M-164/M-164FX/M-164UF
4 − Using the mixer
Adjusting levels
After turning on the power, adjust the level of each
input signal. The following explanation assumes that the
STEREO OUTPUTS are being used as the main outputs.
1 Prepare headphones or an amplification system to
output the sound in advance.
If monitoring with headphones, raise the volume
with the PHONES LEVEL knob slightly.
If monitoring with an amplification system, raise
the input level on the amp slightly.
2 Turn the MONITOR section ST switch ON (push
switch in).
With this set, the level of the signals output from the
STEREO OUTPUTS jacks is shown on the MONITOR
meters.
3 Raise the ST (stereo) fader to the 0 position.
4 For the channel 1–6 inputs, adjust the TRIM knob
for the channel so that the “0” indicator on the chan-
nel level meter lights when a signal is being input
that is at the loudest level ordinarily expected.
For the channel 7–16 inputs, adjust the level at the
sound source so that the “0” indicator on the chan-
nel level meter lights when a signal is being input
that is at the loudest level ordinarily expected.
Input channel
level meter