Tektronix 8.00E+02 Drums User Manual


 
Operating Basics
14
80E00 Electrical Sampling Modules User Manual
Figure 6: Vertical Setup dialog box
Programmer Interface Commands
The remote-programming commands for all sampling modules are documented
in the online Programmer Guide.
User Adjustments
All sampling module setups, parameters, and adjustments are controlled by the
main instrument. To save, recall, or change any module settings, use the
instrument menus or front-panel controls or consult the online help accessed
from the main instrument.
Cleaning
The case of the module keeps dust out and should not be opened. Cleaning the
exterior of the module is usually confined to the front panel. If you desire to
clean the case, first read the entire Installation procedure starting on page 6 for
proper handling of the module. Then remove the module from the main
instrument for cleaning.