Tektronix 8.00E+02 Drums User Manual


 
Specifications
48
80E00 Electrical Sampling Modules User Manual
Table 7: Electrical sampling modules - Signal acquisition
Specifications Characteristics
Real t ime accessory
interface
Tekprobe--SMA interface is provided through the electrical
sampling-module interface, one per vertical channel.
Channel i nput Sampling module Input connector
p
connector
80E02, 80E03, 80E04 Precision 3.5 mm female
connector.
80E01 Precision 2.4 mm female
connector (2.4 mm male to
2.92 mm (K) female adapter,
015-0703-xx, is supplied).
80E06 Precision 1. 85 mm female
connector (V) (2.4 mm male to
2.92 mm (K) female adapter,
015-0703-xx, is supplied).
Number of input Sampling module Channels
p
channels
80E01, 80E06 1
80E02, 80E03, 80E04: 2
n Input impedance
50 Ω ±0.5 Ω
Vertical dynamic
range
1V
pp
(offset ±500 mV)
Vertical operating
range
1
, maximum
±1.6 V
Vertical nondestruct
2
Sampling module Maximum input
range
2
(
M
a
x
i
m
u
m
i
n
p
u
t
80E01, 80E06 2.0 V (DC+peak AC)
(
M
a
x
i
m
u
m
i
n
p
u
t
voltage)
80E02, 80E03, 80E04
3.0 V (DC+peak AC)
Vertical number of
digitized bits
14 bit s full scale
Vertical sensitivity
range
3
The range of available full scale input settings.
10 mV to 1 V full scale
Compensation
temperat ure range
±5_ C about temperature where compensation was performed. If
compartment is changed on the mainframe, a sampling module
extender is employed, or the length of the sampling module extender is
changed, the channel must be recompensated.
n DC voltage
accuracy, single point,
within 5_Cof
compensated
temperat ure
±2mV±0.007 (assigned offset)
±0.02 (vertical value -- assigned offset)
n DC vertical
voltage deviation from
linear least squares fit
±10 mV