Tektronix 8.00E+02 Drums User Manual


 
Reference
26
80E00 Electrical Sampling Modules User Manual
Overview Control elements & resourcesTo take a TDR measurement (cont.)
Take cursor
measurements
22. Read the results in the cursor readout.
In t he figure shown above, waveform cursors are used
to m easure Δv and Δt of the waveform, which could be
used to compute its slope (dv/dt).
23. Press the SETUP DIALOGS button and select the
Cursor tab.
24. Select the Waveform cursor type.
25. From the pop-up list for each of Cursor 1 and Cursor 2,
select your TDR source.
26. Press the SELECT button to toggle selection between
the t wo cursors. The active cursor is the solid cursor.
27. Turn the Adjust knob to position each cursor on the
TDR waveform to measure the feature that interests
you.
Select
source from
pop-up list
Click to access sources
SELECT
button
Adjust knob