Filter
Top Products
Q2 OPERATION AND MAINTENANCE MANUAL 9601 23
AUX 1 (Upper control)
Controls the level of the channel signal fed to the Aux 1 bus. This
signal is normally post-fader, unless the PRE button, just below, is
depressed. Internal links on the module pcb allow the pre-fader
feed to be pre or post-EQ (paired with Aux 2).
AUX 2 (Lower control)
Controls the level of the channel signal fed to the Aux 2 bus. This
signal is normally post-fader, unless the PRE button, just below, is
depressed.
PRE
Selects the signal feed for Auxes 1 and 2 to be pre-fader rather than
post-fader.
AUX 3 (Upper control)
Controls the level of the channel signal fed to the Aux 3 bus.
This signal is normally post-fader, unless the PRE button, just
below, is depressed. Internal links on the module pcb allow the pre-
fader feed to be pre or post-EQ (paired with Aux 4).
AUX 4 (Lower control)
Controls the level of the channel signal fed to the Aux 4 bus. This
signal is normally post-fader, unless the PRE button, just below, is
depressed.
PRE
Selects the signal feed for Auxes 3 and 4 to be pre-fader rather than
post-fader.
DIR
Re-routes the signal on the Aux 4 control to feed the Channel
Direct output. The signal no longer feeds the Aux 4 bus, and can
be used either as an additional single effects send, or as a feed to a
multitrack for example.
Note: Dir and Pre are local to the module, they do not affect the
signal flow on any other module than the one on which they are
located.