The Singing Machine iSM-1010 Karaoke Machine User Manual


 
Warning - Tapping or dropping the microphone while it is on can permanently damage
your microphone. Resist the urge to swing the microphone around by the cord!
PREPARATION
This unit is designed to play CD’s/CD+G’s bearing the identification logo . If
CD’s/CD+Gs do not conform to particular standards, they may not play properly.
Fingerprints and dust should be carefully wiped off with a soft cloth. Wipe in a straight motion
from the center of the disc to the outside edge.
Never use chemicals, such as record cleaning sprays, antistatic sprays or fluids, benzene or
thinner to clean compact discs. These chemicals will permanently damage the plastic
surface of the disc.
Always place the compact disc on the disc tray with the label facing upward. Compact discs
can be played on only one side.
To remove a disc from its storage case, press down on the center of the case and lift the disc
out, holding it carefully by the edges.
Discs should be returned to their cases after use to protect them from dust and scratches.
To prevent warping the disc, do not expose it to direct sunlight, high humidity or high
temperatures for extended periods of time.
Do not apply paper or write anything on either side of the disc. The inks used in some felt-tip
pens may damage the surface of the disc.
PLAYING CD OR CD+G DISC
Adjust MASTER VOLUME control on your unit, TV or audio system to a comfortable level.
Adjust MIC/ECHO/BALANCE controls as needed to achieve the desired mix of music and
vocals through your TV or sound system.
Do not press the disc cover of the CD compartment while it’s playing.
Never place anything on top of the Singing Machine. Foreign objects can damage the unit.
Do not apply excessive force to the disc cover.
Only place one disc in the CD compartment at a time.
TURNING POWER ON/OFF
To power on the karaoke center, press the ON/OFF button, the ON/OFF LED will illuminate.
To turn off the system, press the ON/OFF button again, the ON/OFF LED will turn off.
FUNCTION SELECT
Set the Function Selector to CDG.
LOADING A DISC
Lift the CD door at the OPEN/CLOSE point. Place a disc in the compartment with the printed
side facing upward and the shiny side facing down.
Close the CD compartment. The LED window will display the total number of tracks. (If no
disc is loaded, it will display “ ”).
(Refer to the Trouble Shooting Guide on page E22 if a disc is loaded but the total tracks
do not appear.)
" / "
CD OR CD+G OPERATION
E16
ENGLISH