VocoPro DA2277 Microphone User Manual


 
6
Before Getting Started: Things to Consider
It is very important to read the following instructions prior to starting any installation
procedures. Doing so will ensure a correct installation and may save you some time as well.
Protect Against Power Surges
• Connect all external components before you plug any of their power cords into the 
wall outlet.
• Turn off the DA-2277 before you connect or disconnect any cables.
• Make sure all cables are properly grounded.
Protect Components from Overheating
• Don’t block ventilation holes. Arrange any components so that air can circulate freely.
• Don’t stack components.
• If you place the DA-2277 on a stand, make sure you allow adequate ventilation.
Position Cables Properly to Avoid Audio Interference
• Insert each cable firmly into the designated jack.
• If you place components above the DA-2277, route all cables down the side of the 
back of the DA-2277 instead of straight down the middle of the back of the
DA-2277.
Important Stand and Base Safety Information
Choose the location for your DA-2277 carefully. If the DA-2277 is placed on a stand or
base, ensure that it is of adequate size and strength to prevent it from being accidentally
tipped over, pushed off, or pulled off. This could cause personal injury and/or damage to the
DA-2277.
Unpacking the DA-2277
First carefully unpack all of the box contents. You should
have found the following items with your new DA-2277:
1 DA-2277 Receiver
2 Wireless Microphone Transmitters
2 RCA A/V Patch Cables
1 Four-Pack of AA Rechargeable Batteries
2 Mounting Brackets
7 Mounting Bracket Screws
DIGITAL KEY CONTROLLER
Digital Key Control Mixer with/Dual Rechargeable Wireless Mic System
POWER Down Vocal Partner Vocal Cancel A/V SourceNormal Up
Music
0 0
Mic 3 Input
Remote
Key Control
Mic 3
Mic 1 (wireless)
Mic 2 (wireless)
Echo On Echo On
0
0
5
10
10
0
-15 +15
0
-15 +15
0 10 0 10
9
Mic 4 Input
Delay Repeat Digital Echo Mic 4
Echo On
Mic Master
Bass Treble