Filter
Top Products
9
About the Remote Control
• The area between the remote control
and the main unit must be clear of large
obstacles.
• Do not expose the remote control sensor to
strong lighting, especially an inverter type
fluorescent lamp as this may cause the
remote control to not function properly.
Installing Batteries in the Remote Control
1. Turn the remote control over and slide the battery
compartment cover off.
2. Insert the AAA batteries, positioning them according to
the polarity (+, --) markings on the inside of the battery
compartment.
3. Close the battery compartment cover.
Battery Replacement
If you find that the distance between the remote control and
the main unit must be shorter in order to use the remote
control, this means that the batteries are low and must be
changed. Replace both batteries with new ones.
Battery N
otes:
• Use AAA batteries.
• Be sure the polarities (+, --) are correct.
(See the illustration inside the battery
compartment).
• Remove the batteries when not using the
remote control for an extended period of
time.
• If batteries leak, dispose of them
immediately. Avoid skin, clothing and any
other contact with the leaked material.
Clean the battery compartment thoroughly
before installing new batteries.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-
zinc) with rechargeable (nickel-cadmium)
batteries.
Connecting the Antennas
Connect each of the two included antennas to the
connections labeled ANT A and ANT B on the front panel of
the PA-MAN and turn each clockwise to lock.
Connecting the Power Cable
Plug the supplied AC power cable into the AC inlet after all
other connections are complete and then plug the AC power
cable to an AC wall outlet.
CAUTION
Use the supplied AC cable. Do not use other AC power
cables as doing so may result in fire hazard or electrical
shock.
Getting Started