Filter
Top Products
CVP-305/303/301 Owner’s Manual
207
Appendix
5 Fix the main unit.
1
Center the main unit to
produce equal clearance on
the left and right sides.
2 Use 6x16 mm short screws
to secure the main unit from
the front.
6 Connect the pedal cord.
7 Set the voltage selector and connect the power
cord.
Voltage Selector
Before connecting the AC power cord, check the setting of the
voltage selector which is provided in some areas. To set the
selector for 110V, 127V, 220V or 240V main voltages, use a
“minus” screwdriver to rotate the selector dial so that the correct
voltage for your region appears next to the pointer on the panel.
The voltage selector is set at 240V when the unit is initially
shipped.
After the proper voltage has been selected, connect the AC
power cord to the AC INLET and an AC wall outlet. A plug
adaptor may be also provided in some areas to match the pin
configuration of the AC wall outlets in your area.
WARNING
An improper voltage setting can cause serious damage to
the Clavinova or result in improper operation.
8 Set the adjuster.
Rotate the adjuster until it comes in firm contact with
the floor surface.
■ After completing the assembly, please check
the following.
1 Insert the pedal
cord plug to the
pedal connector.
2 Attach the cord holders
to the rear panel as
shown, then clip the
cord into the holders.
3 Use a vinyl tie
to take up any
slack in the
pedal cord.
240
127
110
220
• Are there any parts left over?
→ Review the assembly procedure and correct any
errors.
• Is the Clavinova clear of doors and other movable
fixtures?
→ Move the Clavinova to an appropriate location.
• Does the Clavinova make a rattling noise when you
shake it?
→ Tighten all screws.
• Does the pedal box rattle or give way when you
step on the pedals?
→ Turn the adjuster so that it is set firmly against the
floor.
• Are the pedal and power cords inserted securely
into the sockets?
→ Check the connection.
• If the main unit creaks or is otherwise unsteady
when you play on the keyboard, refer to the assem-
bly diagrams and retighten all screws.
When moving the instrument after assembly, always
hold the bottom of the main unit.
CAUTION
Do not hold the key cover or top portion. Improper han-
dling can result in damage to the instrument or personal
injury.
Top portion
Key cover
Hold here.
Do not hold here.
Do not hold
here.