Filter
Top Products
Keyboard Stand Assembly
N-100 Owner’s Manual
ENGLISH
28
2-3While supporting B with your hand, pass the
pedal cord (attached to C) through from the
inside to the outside of B.
Position C upside down, then insert it into the
slot on B. Be sure to push C until it stops.
2-4While holding and pressing C securely into the
slot, fix it to B using four long screws (6x20mm).
2-5Turn B so that its bottom side of (the side on
which C is attached) is on the floor.
2-6Pass the pedal cord and power cord into the
groove on B, then attach them to the top of B
using the four vinyl ties.
Be sure to have the end of the power cord extend
past the top edge of B by 20cm or more (roughly
half the length of B).
2-7Replace the plastic cover onto the groove of B.
Do not insert the feet of the groove cover between
the groove socket and groove wall.
3. Fix B to A.
3-1Place B in front of A, with the speaker net on B
facing upward.
3-2Insert the speaker cord plug into the connector on
the bottom surface of A, with the plug’s tab facing
to the rear.
BB
BB
CC
BB
CC
B
At least 20cm
20cm
B
Correct
Incorrect
BB
A