Filter
Top Products
Detailed Settings – [FUNCTION]
P-155 Owner’s Manual
ENGLISH
45
F7.5: Control Change ON/OFF
Normally the instrument will respond to MIDI control
change data received from an external MIDI device or
keyboard, causing the voice on the corresponding chan-
nel to be affected by pedal and other “control” settings
received from the controlling device (the keyboard voice
is not affected).
The instrument also transmits MIDI control change
information when the pedal or other appropriate con-
trols are operated.
This function makes it possible to cancel control change
data reception and transmission so that, for example, the
instrument’s pedal and other controls can be operated
without affecting an external MIDI device.
Setting range: ON/OFF
Default setting: ON
F7.6: Panel/Status Transmit
This function causes all the current instrument panel set-
tings (selected voice, etc.) to be transmitted via the MIDI
OUT terminal.
1. Set up the panel controls as desired.
2. Connect the instrument to a sequencer via MIDI, and
set up the sequencer so it can receive the setup data.
3. Engage the Function and select .
4. Press the [+/YES] button to transmit the panel/status
data.
will appear on the display when the data has been
successfully transmitted.
F7.7: Initial Setup Send
This function lets you send the data of the panel settings
to a computer. By transmitting the panel settings and
recording them on the MIDI sequence recorder prior to
the actual performance data, the instrument will be
automatically restored to the same settings when the per-
formance is played back. You can also use this function to
change the settings of a connected tone generator to the
same settings as the instrument.
1. Set up the panel controls as desired.
2. Connect the instrument to a sequencer via MIDI, and
set up the sequencer so it can receive the setup data.
3. Engage the Function and select .
4. Press the [+/YES] button to transmit the panel/status
data.
will appear on the display when the data has been
successfully transmitted.
The following data can be sent.
•Voice selection
• [REVERB] type
• [REVERB] depth
• [EFFECT] type
• [EFFECT] depth
• Split point
•Tuning (F1)
•Dual detune (F3.2)
For information on control changes that can be used with the instru-
ment, refer to MIDI Data Format on page 62.
Setup Data:
Data that contains a set of panel settings for the instrument.
• See page 63 for a list of the Panel Data Contents transmitted by
this function.
• Receiving the transmitted data:
1. Connect the instrument via MIDI to the device to which the
setup data was transmitted previously.
2. Start sending the setup data from the device.
The instrument automatically receives the setup data, which will
be reflected in the panel settings.
(For the data to be accepted, the instrument that receives the
setup data should be the same model as the one that transmitted
the setup data to the sequencer.)
• For more information on transmitting and receiving setup data via
MIDI, refer to the owner’s manual for the connected MIDI device.
NOTE
NOTE
NOTE