Filter
Top Products
45
u2: Save Panel Settings
This function saves the current settings of all panel controls to disk. The data can then be reloaded at any time by
using the Load Panel Settings function (u3), described next.
ZInsert the Disk and Select a Song Number ..........................................................................................
u4: Save Individual Key Tuning
This function saves the current individual key tuning data set up via the Utility Mode 1 “Individual Key Tuning”
function (U3) to disk. The data can then be reloaded at any time by using the Load Individual Key Tuning function
(u5), described next.
ZInsert the Disk and Select a Song Number ..........................................................................................
Make sure that a properly formatted disk is loaded in the PDP-400 disk drive and se-
lect the song number you want to save the data to. Individual key tuning data can be saved
to a blank song number or one that already contains performance memory data.
XSelect and Execute the Function ..........................................................................................................
Select the “u4” function as described in the introduction to this section, then, while
still holding the [MIDI/TRANSPOSE] button, press the TEMPO [▲] or [▼] button to
begin saving the tuning settings. Simply release the [MIDI/TRANSPOSE] button before
pressing the TEMPO [▲] or [▼] button if you want to cancel the function.
The tuning settings are saved to one song file on the disk. The Save Individual Key
Tuning function will automatically be exited when the data has been saved.
u3: Load Panel Settings
This function reloads the panel settings saved to disk by the Save Panel Settings function (u2), described above.
ZInsert the Disk and Select a Song Number ..........................................................................................
Make sure that the disk containing the saved panel settings is loaded in the PDP-400
disk drive and select the song number you want to load the data from.
XSelect and Execute the Function .........................................................................................................
Select the “u3” function as described in the introduction to this section, then, while
still holding the [MIDI/TRANSPOSE] button, press the TEMPO [▲] or [▼] button to
begin loading the panel settings. Simply release the [MIDI/TRANSPOSE] button before
pressing the TEMPO [▲] or [▼] button if you want to cancel the function.
The Load Panel Settings function will automatically be exited when the data has been
loaded.
Utility Mode 2
Make sure that a properly formatted disk is loaded in the PDP-400 disk drive and se-
lect the song number you want to save the data to. Panel settings can be saved to a blank
song number or one that already contains performance memory data.
XSelect and Execute the Function .........................................................................................................
Select the “u2” function as described in the introduction to this section, then, while
still holding the [MIDI/TRANSPOSE] button, press the TEMPO [
ss
ss
s] or [▼] button to
begin saving the panel settings. Simply release the [MIDI/TRANSPOSE] button before
pressing the TEMPO [▲] or [▼] button if you want to cancel the function.
The panel settings are saved to one song file on the disk. The Save Panel Settings func-
tion will automatically be exited when the data has been saved.