Filter
Top Products
8
Caution
Set up
■ Tuning and Changing the Strings
The Silent Violin™ is shipped from the factory with the
bridge unfitted. First, set up the bridge and then proceed
with tuning. As the strings get old, sound quality will gradu-
ally decrease, and it will become difficult to tune the in-
strument. Change the strings as soon as you think they
are getting old.
• The end of the strings are sharp and can cut fingers. Use cau-
tion when changing strings.
• When changing or adjusting strings, do not put your face close
to the instrument. The string may suddenly break resulting in
eye or other unexpected injuries.
•The lower side of the bridge supports the 1st string (E), the
higher side supports the 4th string (G). Make sure the bridge is
placed properly, then set the bridge in the bridge seat. The side
of the bridge with the logo imprint should face the tailpiece.
• Ensure that the bridge stands vertically. If it leans to one side,
use both hands to adjust. Make sure that each string passes
over the corresponding slits in the bridge.
[Bridge is placed vertically]
[Make sure that the strings do not
come out of their grooves]
E
A
D
G
Protective tube on
the 1st (E) string
Correct
Bridge seat
Tailpiece
Body
Bad
Bad
Vertical
Bridge seat
Bridge feet
[Make sure the bridge feet do not
come in contact with the bridge seat]
E
A
D
G
1st string
4th string
[Looking from the tailpiece]
Groove
Logo imprint
Make sure that the strings are resting in
their appropriate grooves in the bridge when
playing the instrument.
Strings may come out of their grooves when adjusting the bridge
or changing strings. Since the first (E) and fourth (G) strings
tend to come out of their grooves easily, use your fingers to
hold the strings gently in place when tuning the instrument.
Also, the 1st (E) string is fitted with a protective tube. Make sure
that the tube rests on the bridge.
Always make sure that the bridge is standing vertically,
whether the instrument is being played or stored.
Even if the bridge is standing vertically before tuning, it may tilt
during the tuning process. If so, readjust the bridge so it stands
vertically.
It is very important that the bridge stands vertically. If it leans in
either direction it will impair the sound and risk damaging the
instrument.
08.12.3, 5:55 PMPage 8