Filter
Top Products
Keyboard Stand Assembly
Owner’s Manual
58
ENGLISH
Keyboard Stand Assembly
CAUTION
• Assemble the stand on a hard and flat floor with ample space.
• Be careful not to confuse parts, and be sure to install all parts in the correct orientation. Please
assemble the unit in accordance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use only the included screws of the specified sizes. Do not use any other screws. Use of
incorrect screws can cause damage or malfunction of the product.
• Be sure to tighten all screws upon completing assembly of the unit.
•To disassemble the unit, reverse the assembly sequence given below.
Remove all parts from the package and make sure you have all of the items.
Have a Philips-head (+) screwdriver of the appropriate size ready.
B
ED
A
C
C
Foamed styrol pads
Remove foamed styrol pads from the package, position
them on the floor, then place A on top of them.
Position the pads so that they will not hide the connectors
on the bottom of A.
A bundled pedal cord is attached to the reverse side.
6 x 20 mm long screws x 4
6 x 16 mm short screws x 4
4 x 12 mm thin screws x 2
4 x 10 mm thin screws x 2
4 x 20 mm tapping
screws x 4
Headphone hanger
Headphone hanger
Cord holders x 2
Power cord
Assembly Parts
Adjuster (x 1)