Default Settings 19
Default Settings Table 5 shows the default settings for the Switch:
Table 5 Default Settings
Feature Switch
IP Configuration Automatic by DHCP client
Port Status Enabled
Port Speed ■ 10BASE-T/100BASE-TX ports are
auto-negotiated
■ 10BASE-T/100BASE-TX/1000BASE-T port is
auto-negotiated
■ 100BASE-FX port is fixed at 100 Mbps
Duplex Mode ■ 10BASE-T/100BASE-TX port is auto-negotiated
■ 10BASE-T/100BASE-TX/1000BASE-T port is
auto-negotiated (half duplex or full duplex at
10/100 Mbps, full duplex only at 1000 Mbps)
■ 100BASE-FX port defaults to 100 Mbps
full-duplex mode (100 FD) and must be
manually set to half-duplex mode (100 HD) if
required.
Power over Ethernet Enabled (ports 1, 2,5 and 6)
Flow Control ■ Disabled in half duplex 10/100 ports
■ Auto-negotiated in full duplex 10/100 ports
■ Disabled for 10/100/1000 port
Broadcast Storm Control Enabled
Virtual LANs (VLANs) All ports belong to the untagged Default VLAN
(VLAN 1) with IEEE Std 802.1Q-1998 learning
operational
Multicast Filtering IGMP Filtering enabled
Rapid Spanning Tree Protocol Enabled
Spanning Tree Fast Start ■ Disabled on 10/100 ports
■ Disabled on 10/100/1000 port
Traffic Prioritization All ports prioritize NBX VoIP traffic (LAN and IP).
All ports set to “best effort” for all other traffic.
Port Security Disabled per port
