Setup Using Windows NT 3.5.1 RAS 3-19
The Remote Access Setup dialog box appears, as shown in
Figure 3-17.
Figure 3-17 Remote Access Setup Dialog Box
5 If a modem is already configured, select it, and then click
Remove.
6 Click Add.
The Add Port dialog box appears.
7 Select a COM port, and then click OK.
The Remote Access Setup message box appears.
8 Click Cancel.
The Configure Port dialog box appears.
9 Select 3ComImpact IQ for baud rates up to 115.2 Kbps and
then specify the port usage. Click OK.
The 3C882 ISDN modem allows for transfer rates of up to
230.4 Kbps. However, some computers require the installation
of additional hardware, such as an accelerated serial port
card, to take advantage of this higher speed. Additional
configuration steps, as well, are required. Refer to “Setup for
230Kbps” for instructions.
The Remote Access Setup dialog box appears.
