XLB-4232 DC
7-6
10.2 Operation. During operation of the aerial device all platform occupants shall use
appropriate fall protection connected to the aerial device at the platform position.
10.3 Work Platform. The operator shall not use railings, planks, ladders or any other
device in or on the work platform for achieving additional working height or reach.
10.4 Brakes. The vehicle parking brake(s) shall be set at all times that the boom is
elevated except when the aerial device is being used in accordance with 9.5.
10.5 Loading. Any loading which includes a horizontal load shall be avoided unless the
mobile unit is designed for that application.
10.6 Observations. Observations during operation for any defects shall be conducted on
an ongoing basis.
10.6.1 Pre-start Inspection. Items determined by the owner in accordance with the
manufacturer’s recommendations for each specific aerial device shall be inspected
for defects prior to each day’s operation. The following tests and inspections shall
be performed by the operator once daily, prior to first use:
(1) Operating controls and associated mechanisms for conditions interfering
with proper operation.
(2) Visual and audible safety devices for malfunction.
(3) Hydraulic or pneumatic systems for observable deterioration or excessive
leakage.
(4) Fiberglass and other insulating components for visible damage or
contamination.
(5) Missing or illegible operational and instructional markings.
(6) Electrical systems of/or related to the aerial device for malfunction, signs of
excessive deterioration, dirt and moisture accumulation.
(7) Visual inspection of bolts, pins, and other fasteners for loose, deformed or
missing fasteners and other locking devices. Any suspected items shall be
carefully examined or tested and a determination made by a qualified person
as to whether they constitute a safety hazard. All unsafe items shall be
replaced or repaired before use.
10.7 Worksite. Before the aerial device is used the worksite shall be surveyed for
hazards such as:
(1) Untamped earth fills.
(2) Ditches.
(3) Dropoffs and floor obstructions.
(4) Debris.
(5) Overhead obstructions and electrical conductors.
(6) Weather conditions.
(7) Presence of unauthorized persons.
10.8 Precautions. Before and during each use the operator shall:
(1) Check for overhead obstructions and electrical conductors.
(2) Insure that the load on the platform and/or load lifting devices are in
accordance with the manufacturer's rated capacity.
(3) Insure that outriggers and stabilizers are used if the manufacturer's
instructions require their use.
(4) Insure that guardrails are properly installed, and the gates are closed.
(5) Use outrigger pads when necessary to provide firm footing.
10.9 Mobile Operation. Before engaging in mobile operation the operator shall
determine that the aerial device is specifically designed for mobile operation.
10.10 Personnel. Only trained and authorized personnel shall be permitted to operate the
aerial device.
10.11 Training, Retraining, and Familiarization of Operators.
10.11.1 General Training. Only personnel who have received general instructions
regarding the inspection, application and operation of aerial devices, including
recognition and avoidance of hazards associated with their operation, shall
operate an aerial device. Such items covered shall include, but not necessarily be
limited to, the following issues and requirements:
(1) The purpose and use of manuals.
