XLB-4232 DC
3-12
CAUTION
Always cross and attach the safety chains before towing. Failure to attach safety
chains properly will allow tongue to drop in case of ball hitch failure, resulting in
serious damage to the trailer and equipment.
6. Attach the trailer safety chains to the tow vehicle. Make sure the chains cross
under the trailer tongue as shown in (Figure 3-10). If needed, cross the chains
over then under the tow bar to prevent dragging.
SAFETY
CHAINS
BREAKAWAY
SAFETY CABLE
Figure 3-10. Trailer Hitching Checkpoints
7. Connect the trailer lights to the tow vehicle power plug.
8. Before towing the trailer, check the following and make all necessary
adjustments, corrections, or repairs:
a. Check that trailer jack and outriggers are locked in travel positions.
b. Verify that the transport pin secures the lower boom to the trailer frame. If
the boom is not secured, install the transport pin and pin keeper at this time.
c. Verify that all onboard equipment is secured.
d. Check that the BATTERY ON/OFF switch is in the OFF position.
e. Verify that trailer brake lights and marker lights work properly.
f. Check that the trailer tires are evenly inflated and not low on air.
