724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 147
LGB5028A User‘s Manual
Chapter 6: Configuration
Egress:
Port egress rewriting can be one of the parameters listed below:
• Disable: No egress rewrite.
• Enable: Rewrite enable without remapped.
• Remap: DSCP from analyzer is remapped, and the frame is remarked with remapped DSCP value.
Buttons:
Save: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
6.14.7 DSCP-Based QoS
The section will show you how to configure the DSCP-based QoS mode. This page allows you to configure the basic QoS DSCP
based QoS ingress classification settings for all switches.
Web Interface
To configure the DSCP-based QoS Ingress Classification parameters in the Web interface:
1. Click “Configuration,” “QoS,” “DSCP-Based QoS.”
2. Check the box to enable or disable trust DSCP.
3. Scroll to select QoS Class and DPL parameters.
4. Click on the “Save” button to save the setting.
5. To cancel the setting, click the “Reset” button. It will revert to previously saved values.
