8-6
Installation Guide for Cisco Unity 4.0(5) and Later Voice Messaging with Microsoft Exchange 2003/2000 (With Failover Configured)
OL-7371-02
Chapter 8 Installing and Configuring Cisco Unity Software
Installing and Configuring Cisco Unity Software
Step 18 The remainder of the procedure depends on whether the server contains Intel Dialogic D/120JCT-Euro
or D/240PCI-T1 voice cards:
Installing License Files
From the Cisco Unity Installation and Configuration Assistant, you run the Cisco Unity Install License
File wizard second to install the Cisco
Unity license files.
This section contains two procedures. Do the first procedure on the primary Cisco Unity server and the
second procedure on the secondary Cisco
Unity server.
To Install the License Files on the Primary Server
Step 1 Log on to Windows by using the Cisco Unity installation account.
Step 2 On the Install the Cisco Unity License Files page, click Run the Cisco Unity Install License File
Wizard.
Step 3 On the Welcome page, click Next.
Step 4 Click Add.
Step 5 Insert the Cisco Unity license file disk, if applicable.
(When Cisco Unity was registered on Cisco.com, Cisco replied with an e-mail containing attached file(s)
with license(s) for Cisco
Unity features. The instructions in the e-mail directed that the attached files be
saved. For more information, see the
“Obtaining Cisco Unity License Files” section on page 5-4.)
Step 6 Browse to drive A or to the location where the license file(s) have been stored.
Step 7 Double-click the license file to add it to the License Files list.
If prompted, click Yes to copy the license file to the local system.
Step 8 If you are adding more than one license file, click Add, and repeat Step 6 and Step 7 for each license file.
If the server does not contain
Intel Dialogic D/120JCT-EURO
or D/240PCI-T1 voice cards
Check the Yes, I Want to Restart My Computer Now check box, and
click Finish. Cisco
Unity software is now installed.
If the server contains
Intel Dialogic D/120JCT-EURO
or D/240PCI-T1 voice cards
a. Uncheck the Yes, I Want to Restart My Computer Now check
box, and click Finish.
Caution If the Cisco Unity server contains Intel Dialogic
D/120JCT-EURO or D/240PCI-T1 voice cards, do not restart
the server now or you will not be able to access the
Cisco Unity Administrator after Cisco Unity is installed.
b. Do the procedure under “Software Settings” for your voice card in
the
“Voice Cards and PIMG Units” appendix.
c. Restart the Cisco Unity server.
