10
6. Service and Maintenance
6.1 Super Foam Dome
TM
Pump Information
The Super Foam Dome
TM
pump has built-in thermal overload protection, which means
the unit will automatically shut-off when it senses it could reach an overheat level. Once
cooled down, it will reset and is ready to pump again. Once the area to be drained
reaches a maximum of 1/8", unplug the pump or add more foam.
Power cord must always be plugged into the GFI. NEVER place pump in fluid!
Unplug or switch off the unit when fluid has drained to 1/8".
6.2 Getting the most from your Super Foam Dome
TM
Pump
Optimum performance is reached at a maximum 25' hose length. The pump continues to
work at longer lengths.
Make sure the fluid runs smoothly through the hose with no kinks or obstructions! If there
is little or no movement of fluid, that means either there is an air lock or something is
clogging the unit. If the hose is not properly attached or have good rubber washers, it will
reduce the foam output. If the unit is clogged, tip the pump upside down to eject any
foreign object, then flush with fluid.
