![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/9/2f/92f13304-0089-4629-b580-bef2feabb9a1/92f13304-0089-4629-b580-bef2feabb9a1-bg6.png)
5
o WARNING: NEVER plug pump in without Super Foam Dome
TM
unit (fan) being on.
Electrical damage to your motor will occur and as this would immediately void the one-
year warranty.
o GLASS: No glassware or breakables allowed in foam area. If glass breaks in foam
area, evacuate all persons immediately until cleaned up.
o SUPERVISION: No pushing, shoving or horseplay allowed. No diving, running or body
bowling. Intoxicated individuals should leave foam area.
o EXPOSURE TO FOAM: Avoid prolonged eye contact. Wash eyes with water if irritated.
Always rinse body after having contact with foam just as you would after contact with
soap, to prevent excess drying of skin. If irritation or allergic reaction occurs, individual
should leave foam area immediately and wash irritated area. Do not wear soaked
clothing for more than 4 hours without rinsing.
5. Operating the Super Foam Dome
TM
WARNING: FAILURE TO FOLLOW ALL SAFETY RULES AND INSTRUCTIONS LISTED
BELOW MAY RESULT IN SERIOUS INJURY TO YOURSELF OR OTHER
PARTICIPANTS OF THIS EFFECT.
5.1 Selecting the location
1. The slippery substance of foam on a slick floor can create a dangerous environment,
which could cause someone to fall. For safety reasons, the makers of the Super Foam
Dome
TM
require using this machine or Foam Dome
TM
Fluid on a non-slip surface such as
indoor/outdoor carpeting, turf, or asphalt.
2. Make sure unit is in a well-supported and secure location before supplying power and
fluid to unit. Shield should be facing the floor with the modulator (sock) pointing straight
down. Never point modulator upward as this would cause electrical damage and ruin your
unit.
3. The height of the machine above the drum decides how fast it will pump fluid. The higher
the machine, the slower the fluid will flow through to the Super Foam Dome
TM
. This unit
is designed to be suspended 12’ to 16’ above the floor with the fluid on the floor. Never
place fluid reservoir level with or higher than the Super Foam Dome
TM
as this will cause
siphoning and dripping and will not stop fluid when turned off.
5.2 Electrical Power Requirements
1. This machine requires a grounded 110VAC/20A circuit for operation. The Super Foam
Dome
TM
draws approximately 20 amps at 110 VAC. During Super Foam Dome
TM
operation this circuit should be dedicated to the Super Foam Dome
TM
. If you have any
doubts about the capacity or grounding of your existing circuits, consult a qualified
electrician.