Dell GX1 P Manual

A SERVICE OF

next previous

Installing Drives 7-3

)LJXUH 5HPRYLQJWKH)URQW%H]HO

While pressing the tab release, tilt the bezel away from the chassis, disengage the

two retaining hooks at the bottom of the bezel, and carefully pull the bezel away from

the chassis.

To replace the bezel, fit the two retaining hooks on the bezel into their corresponding

slots at the bottom of the chassis. Then rotate the top of the bezel toward the chassis

until the top tabs snap into their corresponding slots on the bezel.

5HPRYLQJDQG5HSODFLQJ)URQW3DQHO

,QVHUWV



Empty drive bays contain a front-panel insert to protect the inside of the computer

from dust particles and also to ensure proper airflow within the computer. Before you

install a drive in an empty drive bay, you must first remove the front-panel insert.

To remove the insert covering a 5.25-inch bay,

follow these steps:

 7XUQRIIW KHV\VWHPLQF OXGLQJDQ\DWW DFKHGSHULSKHUDOVDQGGLVF RQQHFW

DOOWKHDOWHUQDWLQJFXUUHQW $&SRZ HUFDEOHVIURPWKHLUSRZHUVRXUFHV

&$87,216HH´3URWHFWLQJ$JDLQVW(OHFWURVW DWLF'LVFKDUJHµLQWKHVDIHW\

LQVW UXFWLR QVDWWKHIURQWR IWKLVJXLGH

 5 HPRYHWKHFRPSXWHUFRYHUDVLQVWUXFWHGLQ´5HPRYLQJWKH& RPSXW HU

&RYHUµLQ&KDSWHU

tab release

retaining hooks (2)