Dell GX1 P Manual

A SERVICE OF

next previous

7-12 Dell OptiPlex GX1 and GX1p Mini Tower Managed PC Systems Reference and Installation Guide

 5HPR YHWKH GULYH EUDFNHWIU RPWKH FKDVVLV

If a hard-disk drive is already installed in the drive bracket, disconnect the DC

power cable and EIDE cable from the drive.

Remove the screw securing the hard-disk drive bracket to the drive cage in the

chassis.

Grasp the bracket, and rotate it outward from the chassis until the sliding tab

clears the slide rail on the drive cage (see Figure 7-10). Lift the bracket up slightly

to free its hinge tabs from the chassis slots.

.

)LJXUH5HPRYLQJWKH+ DUG'LVN'ULYH%UDFNHW

 6 OLGHWK HGULYHLQWRWKHFKRVHQED\RIWKHE UDF NHWRULHQWHGVRWKDWWKH

F RQQHFWRUVRQWKHE DFNRIWKHGULYHZLOOIDFHWKHEDFNRIWKHFKDVVL V

ZKHQWKHEUDFNHWLVUHLQVWDOOHG VHH)LJX UH 

 $OLJQWKHI RXUVFUHZKROHVRIWKHGULYHDQGEUDFNHW,QVHUWDQGWLJKWHQ

WKHVFUHZVWKDWFDPHZLWK\RXUXSJUDGHNLW

If you are installing a drive in the 1.6-inch bay, use the four screw holes in the side

of the bracket (see Figure 7-11). If you are installing a drive in the 1-inch bay, use

the four screw holes in the bottom of the bracket.

sliding tab

hinge tabs

drive-cage slide rail

chassis slots