A SERVICE OF

logo

Effective March, 1998
IL 33-A1C-1
Page 7
Step 6: Installing the Reset Link Assembly
A. Remove and scrap the roll pin from the right
end of the Breaker Trip Shaft. Install the new roll
pin supplied in the Breaker Trip Shaft as shown.
B. Remove and scrap the Wrist Pin and hardware
that connects the Insulation Link to the Breaker
Pole Shaft for Phase 3.
C. Install (1) Tru-arc lock ring and (1) flat washer
on one end of the Wrist Pin. Completely insert
the Wrist Pin into the Insulation Link and
Breaker Pole Shaft from the left side.
D. Slide (1) flat washer, then the Reset Link
Assembly, then another flat washer onto the
Wrist Pin as shown. Install (1) Tru-arc lock ring
on the right end of the Wrist Pin.