A SERVICE OF

logo

The Harmonizer
Programmer’s Manual
The Harmonizer
Programmer’s Manual Page 47 of 97 Release 1.2.1
1999 Eventide, Inc.
If the userobject outputs are connected in a different
order, the menu page items might not only look bad but
might not all fit on the same menu page. For instance,
connecting the userobject outputs in this order:
1. main fader-obj
2. left low knob-obj
3. left high knob-obj
4. meter-obj
5. right low knob-obj
6. right high knob-obj
results in two menu pages
(accessible via a stacked SOFT KEY)!
Since parameters are always placed from upper left to lower right,
top to bottom, once the meter monitor is placed, (not fitting
below the left highs parameter) there is no more room below the
meter or to the right of the meter on the first menu page.
Therefore, a new menu page is created for the latter two knob
parameters.