The Harmonizer
Programmer’s Manual
The Harmonizer
Programmer’s Manual Page 89 of 97 Release 1.2.1
1999 Eventide, Inc.
Vfader Module
The vfader module creates a graphic on the
PARAMETER
screen. The graphic, including title, takes up four lines of the
screen and one sixth of the width of the screen. Up to six of
these modules can fit on one menu page.
Six characters of the
8 char name are displayed in the graphic as
a title. Refer to the Modules Section for complete information.
Textknob Module
The textknob module creates a multiple choice selection in a
single line by half screen width area of a
PARAMETER area menu
page.
The choices appear in place of the
%s in the menu statement.
The
8 char name is only used if the module’s userobject is
connected to the head module. The control output reflects
which selection is made. If the 1st selection is made the output
will equal 0. If the 3rd selection is made, the output value will
equal 2. Refer to the Modules Section for complete information.
C
ONTROL SIGNAL MONITORS
Just as “parameter adjuster” modules are used to generate control signals and are displayed as parameters in
PARAMETER area menu pages, control signal monitor modules monitor the value of control signals and may
be displayed on those same menu pages.
Graphical Control Signal Monitors
There are five different monitor modules. Three of these, the
hmonitor, meter, and vmonitor modules, produce
graphical displays. The screen to the right (taken from the program
Interface Modules
from the “
Programming
” bank) shows the three
graphical monitors
(among others).
Each of the graphical control signal monitor modules has a
control signal input and four specifiers:
minimum, maximum,
name and tag.
•
minimum sets the lowest value that may be indicated by the
monitor.
• maximum sets the highest value that may be indicated by the
monitor.
• For vmonitor and hmon, the tag specifier is used to generate the text for the monitor.
