230
250C
8Ć43 TroubleshootingC4699Ć90000
Input/Output Test for the DesignJet 230/250C Only
The input/output test performs the following:
D Parallel input/output test: Reads the data and status registers of the BiĆTronics PAL.
(Tests only a small portion of the BiĆTronics input/output functionality.)
D Serial input/output test: Verifies the ability of the RSĆ232ĆC interface to send and receive
data. This test uses a special loopback connector (part number 07440Ć60302) to connect
the output to the input.
1 Connect the loopback connector to the serial port of the plotter.
If a connector is not available, you can place a jumper between pins 2 and 3 of the
serial port for the test.
2 In service mode 2, hold down the
SHIFT key and press Input/Output test.
Input/Output
Test
Shift
The
Load Media
LED (or the
Ready
LED, if you have
already loaded media) turns off while the plotter performs the
input/output test.
The shift key does not act as a
stop-the-test
key for this test.
Status. If the test does not find an error, the
Load Media
LED (or the
Ready
LED, if
you have already loaded media) turns on again. Otherwise, an error is reported by an
error code on the front panel.
