Appendix B Control Panel Menus 378
Configuration Menu
PCL MEMORY=
400K
0K and up
(This value
depends on
the amount of
installed
memory.)
This item appears only when RESOURCE SAVE=ON. Select
the amount of memory used for saving PCL resources.
Printer default is the minimum amount of memory needed
to perform resource saving for PCL. Press -V
ALUE
+ to
change settings by increments of 10 (up to 100 KB) or by
increments of 100 (above 100 KB).
For more information, see page 401
.
PS MEMORY=
400K
0K and up
(This value
depends on
the amount of
installed
memory.)
This item appears only when RESOURCE SAVE=ON. Select
the amount of memory used for saving PS resources.
Printer default is the minimum amount of memory needed
to perform resource saving for PS. Press -V
ALUE
+ to
change settings by increments of 10 (up to 100 KB) or by
increments of 100 (above 100 KB).
For more information, see page 401
.
PAGE PROTECT=
AUTO
AUTO
ON
This item appears only after a 21 PAGE TOO COMPLEX,
PRESS GO TO CONTINUE message displays (page 211
).
Memory Enhancement technology (MEt) attempts to
guarantee that all pages will print. If the page does not
print, turn PAGE PROTECT to ON. This might increase
chances of a 20 INSUFFICIENT MEMORY, PRESS GO TO
CONTINUE message. If this occurs, simplify the print job or
install additional memory (page 392
).
Item Values Explanation
