Specifications - Scanner Module Design
158 HC900 Hybrid Controller Installation and User Guide Revision 5
9/03
Scanner Module Design
Controller Module
Feature
Description
Module design
CPU
Memory
Bus
Communications
Status Indicators
Input/Output
Plug-in module: CPU, memory (RAM and Flash PROM), communications connector,
backplane connector, and support components on a single wiring board.
33 MHz RISC-Based Processor
Includes: embedded MAC for Ethernet support; 6 DMA channels (including 2
dedicated for MAC support)
RAM: 8 Megs SDRAM
Flash (PROM): 2 Megs Dual Backed Flash Memory
16-Bit Address and Data Bus (PROM and RAM)
Ethernet 10Base-T Port: RJ45 connector on CAT 5 cable; connects I/O on Scanner
Module to:
- Controller Module, or to
- third-party Hub
Scanner Status: Bi-Colored LED
Backplane: 40-pin Samtec connector -
- Receives power (5 Vdc and 24 Vdc) from power supply
- Serial Peripheral Interface (SPI) for I/O Modules in Local Rack
- diagnostic sensing for I/O slots in this rack
