A SERVICE OF

logo

Installation Guide - Overview
Revision 5 HC900 Hybrid Controller Installation and User Guide 55
9/03
Step Procedure Comments/References
6
Ensure that jumpers are
installed in J9 on the
Controller Module as
shown at right.
7
Ensure that AC power to
the rack is disconnected.
Carefully place the
Controller Module in the
local rack, immediately to
the right of the Power
Supply. Fasten it in place
with two captured screws
at top and bottom.
ATTENTION:
Do not install the battery
at this time. Installing the
battery before the
controller is configured
can substantially shorten
battery life. Install under
power after the controller
configuration is complete.
(For more information,
refer to Battery
Installation/Replacement,
page 152.)