5. Press F. The display will
change to a format like figure 5-
36 with the cursor over the
reference waypoint field.
6. Use the right inner and outer
knobs to select the identifier of
the desired reference waypoint
(figure 5-37).
7. Press F. The waypoint page
for the waypoint you just entered
will be displayed (figure 5-38).
8. Press F again to approve the
waypoint. You will be returned to
the waypoint creation page.
9. Use the right inner and outer
knobs to select the desired radi-
al. Notice that you may enter
the angle down to the tenth of a
degree (figure 5-39).
10. Press F to approve the radial.
The cursor will move to line 4.
11. Use the right inner and outer
knobs to select the desired dis-
tance from the reference
waypoint (figure 5-40).
12. Press F to approve the dis-
tance. The cursor will
automatically be removed from
the screen.
KLN 94 Pilot’s Guide Chapter 5 Intermediate Operation
5-13
Figure 5-36
Figure 5-37
Figure 5-38
Figure 5-39
Figure 5-40
