LXE E-EQ-RX2OGWW-B Manual

A SERVICE OF

next previous

8 Mounting the RX2

RX2 User’s Guide E-EQ-RX2OGWW-B

Mounting the RX2

2

3

4

1

1.

2.

3.

4.

Set Screws (4 each)

Lock Nuts (4 each)

Set Screw Holes (4)

Hook

Figure 4 Mounting Provisions

To install the RX2:

1. Install the bracket by placing the hook (at the bottom of the bracket) over the lip of a

Cascade

®

E or F series side shifter.

2. Slide the RX2 over to the desired position.

3. Secure with (4) 1/4-20 set screws in the threaded holes on the top surface of the

bracket. Thread a lock nut onto each set screw. Using an Allen wrench, tighten all

four set screws to an equal depth, but do not tighten the locking nuts yet.

4. After all set screws have been tightened, recheck and retighten all screws. Tighten

the locking nut while holding the set screw tight with an Allen wrench.