SNMP Traps
B-2
8000-A2-GB20-50April 2000
Enable DSL Port Traps
"
Procedure
To enable DSL Port Traps:
1. Follow this menu sequence from the DSL Main Menu:
Configuration →Ports →DSL Ports (A-B-B)
2. Select a DSL port.
3. If desired, enter a value for the following:.
— Margin Threshold
— Link Down Count Threshold
— Error Rate (minute) Threshold.
— Error Rate (hour) Threshold.
See Table 3-2, Port Options, in Chapter 3, RADSL Card Configuration, for
more information.
4. Reset the port following this menu sequence:.
Configuration →Interfaces →Control (A-C-C)
See Table 3-3, Interfaces Options, in Chapter 3, RADSL Card Configuration,
for more information.
