18
STEP 7B: INSTALL THE CABLES
2, 4
1
5, 4
3
INSTALL BOLT
AFTER CABLE
IMPORTANT!
1. Route the cable as shown, installing
the associated pulleys and hardware
as you go along.
2. After assembly, make sure the cable
and pulleys can move freely.
3. Tighten ALL the hardware.
ITEM PART NO.DESCRIPTION QTY.
1 B 900 PULLEY, 4-1/2” DIA. 1
2 C 448 SCREW, 3/8”-16 X 1-3/4” HHCS 1
3 C 802 SCREW, M4 X 20mm PAN HD. 1
4 C 754C FLAT WASHER, 3/8” 2
5 C 766A LOCKNUT, 3/8”-16 1
PLACE THE SELECTOR PIN IN THE CAP PLATE. ADJUST THE ARMS TO A MIDDLE
POSITION ON THE ADJUSTMENT DISC (45 DEGREES). MOVE THE ARMS INWARD
FROM THIS POSITION.... THEN OUTWARD. WATCH THE CAP PLATE ON THE
WEIGHT STACK. NOTICE IF THERE IS A LAG BETWEEN THE INNER AND OUTER
MOVEMENTS. ADJUST THE TRAVEL STOP TO TENSION THE CABLE. THIS WILL
REMOVE THE LAG BETWEEN INNER AND OUTER MOVEMENT.
